LUGGAGE COMPARTMENT DOOR OPENER MAIN SWITCH INSTALLATION


  1. INSTALL LUGGAGE DOOR OPENING CANCEL SWITCH ASSEMBLY


    1. Engage the 2 claws to install the luggage door opening cancel switch assembly.

  2. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY


    1. Connect each connector.

    2. A01G69C

      Engage the 5 claws as shown in the illustration.

    3. Install the 2 screws <E>.

    4. A01G6BL

      Open the lower instrument panel sub-assembly door as shown in the illustration.

    5. Install the lower instrument panel sub-assembly with the 3 screws <E>.

  3. INSTALL INSTRUMENT PANEL BOX DOOR COVER


    1. A01G6A8

      Engage the 4 claws to install the instrument panel box door cover as shown in the illustration.

    2. A01G83S

      Close the lower instrument panel sub-assembly door as shown in the illustration.

  4. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. A01G5WSE01
      Text in Illustration
      *1 Airbag Connector Lock
      *2 Airbag Connector

      Connect the airbag connector to the lower No. 2 instrument panel airbag assembly.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.

    4. Push in the airbag connector lock to install the airbag connector.

    5. Engage the 5 claws and 2 guides to temporarily install the lower No. 2 instrument panel airbag assembly.

    6. Install the 3 bolts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note

      Confirm that the lower No. 2 instrument panel airbag assembly is installed securely without any excessive gaps and is not protruding outward.

  5. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    1. Connect the connector.

    2. A01G4TS

      Engage the 2 guides, claw and 4 clips to install the No. 2 instrument panel under cover sub-assembly as shown in the illustration.

  6. INSTALL INSTRUMENT SIDE PANEL RH


    1. A01G5BG

      Engage the 2 guides as shown in the illustration.

    2. A01G9H5

      Engage the 2 claws and 4 clips to install the instrument side panel RH as shown in the illustration.

  7. INSTALL FRONT DOOR OPENING TRIM COVER RH

    Tech Tips

    Use the same procedure as for the LH side Click here.

  8. INSTALL COWL SIDE TRIM BOARD RH

    Tech Tips

    Use the same procedure as for the LH side Click here.

  9. INSTALL FRONT DOOR SCUFF PLATE RH

    Tech Tips

    Use the same procedure as for the LH side Click here.

  10. INSTALL LOWER CENTER INSTRUMENT PANEL FINISH PANEL


    1. A01G96C

      Engage the 2 claws and 5 clips to install the lower center instrument panel finish panel as shown in the illustration.

  11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  12. INSPECT SRS WARNING LIGHT

    Click here