HOOD LOCK CONTROL CABLE ASSEMBLY REMOVAL


  1. REMOVE COOL AIR INTAKE DUCT SEAL


    1. A01G7XF

      Remove the 9 clips and cool air intake duct seal.

  2. REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System)

    Click here

  3. REMOVE FRONT WHEEL LH

  4. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH

    Tech Tips

    Use the same procedure for the RH side and LH side Click here.

  5. REMOVE FRONT FENDER LINER LH

    Tech Tips

    Use the same procedure for the RH side and LH side Click here.

  6. REMOVE FRONT DOOR SCUFF PLATE LH


    1. A01G8TA

      Disengage the 10 claws and remove the front door scuff plate LH.

  7. REMOVE COWL SIDE TRIM BOARD LH


    1. A01G75T

      Remove the clip.

    2. Disengage the claw and clip, and remove the cowl side trim board LH.

  8. DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    1. A01G4MG

      Disengage the claw and 2 guides to disconnect the hood lock control lever sub-assembly.

  9. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    1. A01G6UL

      Disconnect the hood lock control cable assembly and remove the hood lock control lever sub-assembly.

  10. REMOVE HOOD LOCK ASSEMBLY


    1. A01G8O0

      Disconnect the connector.

    2. Disengage the clamp.

    3. A01G4U6

      Remove the 3 bolts.

    4. A01G461

      Disconnect the hood lock control cable assembly and remove the hood lock assembly.

  11. REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY


    1. Using a screwdriver, disengage 5 clamps and hood cable grommet as shown in the illustration.

      A01G4B6E01
      Text in Illustration
      *1 Hood Lock Control Cable *2 Hood Cable Grommet
      *3 Washer Hose - -

      Tech Tips

      Tape the screwdriver tip before use.

    2. Pull the hood lock control cable assembly from the engine compartment and remove it.