SLIDING ROOF SWITCH ASSEMBLY INSPECTION


  1. INSPECT SLIDING ROOF SWITCH (ROOF CONSOLE BOX ASSEMBLY)


    1. A01G6IRE01
      Text in Illustration
      *a

      Component without harness connected

      (Sliding Roof Switch (Roof Console Box Assembly))

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      23 (UP) - 19 (GND) UP switch is pressed Below 1 Ω
      23 (UP) - 19 (GND) UP switch is not pressed 10 kΩ or higher
      24 (DOWN) - 19 (GND) DOWN switch is pressed Below 1 Ω
      24 (DOWN) - 19 (GND) DOWN switch is not pressed 10 kΩ or higher
      11 (OPN) - 19 (GND) OPEN switch is pressed Below 1 Ω
      11 (OPN) - 19 (GND) OPEN switch is not pressed 10 kΩ or higher
      12 (CLS) - 19 (GND) CLOSE switch is pressed Below 1 Ω
      12 (CLS) - 19 (GND) CLOSE switch is not pressed 10 kΩ or higher

      If the result is not as specified, replace the sliding roof switch (roof console box assembly).