PRE-CRASH SAFETY SYSTEM HOW TO PROCEED WITH TROUBLESHOOTING

Tech Tips


  • Use the following procedure to troubleshoot the pre-crash safety system.

  • *: Use the GTS.


  1. VEHICLE BROUGHT TO WORKSHOP


    NEXT

  2. INSPECT BATTERY VOLTAGE


    1. Measure the battery voltage with the engine switch off.

      Standard voltage
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.


      NG

      CHARGE OR REPLACE BATTERY
      OK

  3. CHECK CAN COMMUNICATION SYSTEM*


    1. Use the GTS to check if the CAN communication system is functioning normally Click here.

      Result
      DTC Condition Proceed to
      CAN DTC is not output A
      CAN DTC is output B

      B

      GO TO CAN COMMUNICATION SYSTEM Click here

      A

  4. CHECK FOR DTC*


    1. Check for DTCs Click here.


      1. Record the DTCs.

    2. Clear the DTCs.

    3. Recheck for DTCs.


      1. Attempt to duplicate the malfunction and check if the DTCs are output again Click here.

        Result
        DTC Condition Proceed to
        DTCs are not output A
        DTCs are output B
        No DTCs are output, and malfunction cannot be duplicated or checked C

      B

      GO TO DTC CHART Click here

      C

      GO TO SYMPTOM SIMULATION Click here

      A

  5. PROBLEM SYMPTOMS TABLE


    1. Refer to Problem Symptoms Table Click here.

      Result
      Result Proceed to
      Fault is not listed in Problem Symptoms Table A
      Fault is listed in Problem Symptoms Table B

      B

      Go to step 7
      A

  6. OVERALL ANALYSIS AND TROUBLESHOOTING*


    1. Data List / Active Test Click here

    2. Terminals of ECU Click here


      NEXT

  7. ADJUST, REPAIR OR REPLACE


    NEXT

  8. CONFIRMATION TEST


    NEXT
    END