CENTER AIRBAG SENSOR ASSEMBLY INSTALLATION


  1. INSTALL AIRBAG SENSOR ASSEMBLY


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. A01G8QKE01
      Text in Illustration
      *a Fulcrum Length

      Using SST, install the airbag sensor assembly with the 3 bolts.

      SST
      09961-00950
      Torque:
      without SST
      18 N*m  { 178 kgf*cm, 13 ft.*lbf }
      with SST
      11 N*m  { 112 kgf*cm, 8 ft.*lbf }

      Note


      • Use a torque wrench with a fulcrum length of 250 mm (9.84 in.).

      • This torque value is effective when SST is parallel to a torque wrench.

      • If the airbag sensor assembly has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.

      • When installing the airbag sensor assembly, be careful that the SRS wiring does not interfere with or is not pinched between other parts.

      • When the engine switch is first turned on (IG) after the airbag sensor assembly has been replaced, make sure that no one is in the vehicle.

    4. A01G6E9E01
      Text in Illustration
      *1 Waterproof Sheet

      Connect the connectors to the airbag sensor assembly as shown in the illustration.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.

    5. Check that the waterproof sheet is properly set.

    6. Check that there is no looseness in the installed parts of the airbag sensor assembly.

  2. INSTALL NO. 1 CONSOLE BOX DUCT


    1. Install the No. 1 console box duct with the clip.

  3. INSTALL NO. 1 CONSOLE BOX MOUNTING BRACKET

    for U660E Automatic Transmission / Transaxle: Click here

    for U760E Automatic Transmission / Transaxle: Click here

  4. INSTALL FLOOR CARPET BRACKET LH


    1. Engage the 2 guides.

    2. Install the floor carpet bracket LH with the 2 clips.

  5. INSTALL FLOOR CARPET BRACKET RH


    1. Engage the 2 guides.

    2. Install the floor carpet bracket RH with the 2 clips.

  6. INSTALL REAR CONSOLE BOX ASSEMBLY

    Click here

  7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  8. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  9. INSPECT SRS WARNING LIGHT

    Click here

  10. PERFORM YAW RATE AND ACCELERATION SENSOR ZERO POINT CALIBRATION

    Tech Tips


    • When the airbag sensor assembly is replaced, perform zero point learning for the yaw rate and acceleration sensor Click here.

    • The yaw rate and acceleration sensor is built into the airbag sensor assembly.