REAR SEAT SIDE AIRBAG ASSEMBLY INSTALLATION

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.


  1. INSTALL REAR SEAT AIRBAG ASSEMBLY

    CAUTION:


    • The nuts must not be reused.

    • Make sure that the bench type rear seatback pad is not deformed. If it is, replace it with a new one.


    1. Install the rear seat airbag assembly with 4 new nuts.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }
    2. A01G9D7E01
      Text in Illustration
      *1 Hog Ring
      *2 Clamp
      *3 Fastener

      Using hog ring pliers, install 3 new hog rings.

      Note


      • Be careful not to damage the bench type rear seatback cover.

      • When installing the hog rings, take care to minimize wrinkles as much as possible.

    3. Engage the clamp and the fastener to secure the airbag wire harness.

  2. INSTALL REAR SEATBACK ASSEMBLY


    1. Place the rear seatback assembly in the cabin.

      Note

      Be careful not to damage the vehicle body.

    2. Engage the 3 hooks.

    3. Connect the rear seat 3 point type outer belt assembly LH, rear seat 3 point type outer belt assembly RH and rear seat inner with center belt assembly LH to the rear seatback assembly.

    4. Install the rear seatback assembly with the 4 bolts.

      Torque:
      18 N*m  { 184 kgf*cm, 13 ft.*lbf }

    5. Engage the 2 clamps to connect the 2 rear seat airbag assembly wire harnesses.

    6. Connect the 2 rear seat airbag assembly connectors.

    7. A01G97V

      Engage the claw to connect the rear center seat shoulder belt guide.

    8. A01G997

      Engage the claw to connect the rear seat shoulder belt guide RH.

    9. A01G9OK

      Engage the claw to connect the rear seat shoulder belt guide LH.

  3. INSTALL REAR SEAT CUSHION ASSEMBLY


    1. Place the rear seat cushion assembly in the cabin.

      Note

      Be careful not to damage the vehicle body.

    2. w/ Climate Control Seat System:


      1. Connect the rear seat heater connector.

    3. Pass the buckle of the rear seat inner with center belt assembly LH and buckle of the rear seat inner with center belt assembly RH through the rear seat cushion assembly.

    4. A01G54JE01
      Text in Illustration
      *1 Rear Seatback Hinge Hook

      Engage the 2 hooks <B> on rear side of the rear seat cushion assembly to the rear seatback hinge hook.

    5. Engage the 2 hooks <A> on the front side of the rear seat cushion assembly to the vehicle body as shown in the illustration.

    6. Confirm that the rear seat cushion assembly is firmly installed.

      Note

      When installing the rear seat cushion assembly, make sure that the seat belt buckles are not under the rear seat cushion assembly.

  4. INSTALL REAR CENTER SEAT HEADREST ASSEMBLY

  5. INSTALL REAR SEAT HEADREST ASSEMBLY

  6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  7. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  8. INSPECT SRS WARNING LIGHT

    Click here