FRONT PASSENGER AIRBAG ASSEMBLY INSTALLATION

INSTALL NO. 2 INSTRUMENT PANEL WIRE

Text in Illustration
*1	Airbag Connector
*2	Airbag Connector Lock

Connect the 2 airbag connectors of the No. 2 instrument panel wire to the instrument panel passenger airbag assembly.

Note

When connecting any airbag connector, take care not to damage the airbag wire harness.
Be sure to only connect the connectors to each corresponding color.

Push in the 2 airbag connector locks to install the 2 airbag connectors to the instrument panel passenger airbag assembly.
Engage the clamp.

INSTALL INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY
1. Engage the 3 hooks.
2. Push in the instrument panel passenger airbag assembly to engage the 3 hooks.
3. Install the 2 screws to install the instrument panel passenger airbag assembly.
4. Engage the 2 clamps.
INSTALL INSTRUMENT PANEL SAFETY PAD ASSEMBLY
1. Engage the 4 guides and temporarily install the instrument panel safety pad assembly as shown in the illustration.
  Note
  
  Do not damage the instrument panel safety pad assembly.
  
  Do not allow the wire harnesses to interfere with the surrounding parts.
2. Install the 3 clips.
3. Install the 5 bolts <C> and nut <F>.
4. Install the 2 bolts <A>.
  
  Torque:
  
  20 N*m { 204 kgf*cm, 15 ft.*lbf }
5. Engage the 2 claws to connect the cooler (room temp. sensor) thermistor.
6. Engage the claw and each clamp.
7. Connect each connector.
CONNECT NO. 2 INSTRUMENT PANEL WIRE
1. Check that the engine switch is off.
2. Check that the cable is disconnected from the negative (-) battery terminal.
  
  CAUTION:
  
  Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
3. Connect the connector.
  
  Note
  
  When connecting any airbag connector, take care not to damage the airbag wire harness.
INSTALL INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY

Click here
PERFORM DIAGNOSTIC SYSTEM CHECK

Click here