SEAT POSITION SENSOR INSTALLATION


  1. INSTALL SEAT POSITION AIRBAG SENSOR


    1. A01G4ZY

      Engage the pin to install the seat position airbag sensor to the seat slide position sensor protector as shown in the illustration.

    2. A01G525E17
      Text in Illustration
      *1 Seat Position Airbag Sensor
      *2 Feeler Gauge
      *3 Seat Rail
      *a 1.3 mm (0.0512 in.)

      Using a 1.3 mm (0.0512 in.) feeler gauge, temporarily install the seat position airbag sensor with the "TORX" bolt.

      Note


      • If the seat position airbag sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the seat position airbag sensor with a new one.

      • When installing the seat position airbag sensor, be careful that the SRS wiring does not interfere with or is pinched between other parts.

    3. Using a T30 "TORX" socket wrench, tighten the "TORX" bolt.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

    4. Make sure that the clearance between the seat position airbag sensor and seat rail is 1.3 mm (0.0512 in.).

    5. Connect the connector.

    6. Check that there is no looseness in the installed parts of the seat position airbag sensor.

  2. INSTALL FRONT SEAT ASSEMBLY LH

    Click here