KNEE AIRBAG ASSEMBLY (for Driver Side) INSTALLATION


  1. INSTALL TIRE PRESSURE WARNING RESET SWITCH


    1. Engage the 2 claws to install the tire pressure warning reset switch to the lower No. 1 instrument panel airbag assembly.

  2. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. A01G946E01
      Text in Illustration
      *1 Airbag Connector
      *2 Airbag Connector Lock

      Connect the airbag connector to the lower No. 1 instrument panel airbag assembly.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.

    4. Push in the airbag connector lock to install the airbag connector.

    5. Engage the 2 claws to connect the DLC3.

    6. Connect the connector and engage the clamp to install the wire harness.

    7. Engage the 2 hooks to temporarily install the lower No. 1 instrument panel airbag assembly.

    8. Install the 4 bolts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note

      Confirm that the lower No. 1 instrument panel airbag assembly is installed securely without any excessive gaps and is not protruding outward.

  3. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL


    1. Connect each connector.

    2. Engage the 12 claws, 2 clips and guide.

    3. Install the lower No. 1 instrument panel finish panel with the 2 bolts <B>.

  4. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    1. Engage the claw and 2 guides to connect the hood lock control lever sub-assembly.

  5. INSTALL INSTRUMENT SIDE PANEL LH


    1. A01G990

      Engage the 2 guides.

    2. A01G8LE

      Engage the 2 claws and 4 clips to install the instrument side panel LH as shown in the illustration.

  6. INSTALL FRONT DOOR OPENING TRIM COVER LH


    1. Engage the guide.

    2. Engage the 3 claws to install the front door opening trim cover LH.

  7. INSTALL COWL SIDE TRIM BOARD LH


    1. Engage the clip and claw.

    2. Install the cowl side trim board LH with the clip.

  8. INSTALL FRONT DOOR SCUFF PLATE LH


    1. Engage the 10 claws to install the front door scuff plate LH.

  9. INSTALL LOWER CENTER INSTRUMENT PANEL FINISH PANEL


    1. A01G96C

      Engage the 2 claws and 5 clips to install the lower center instrument panel finish panel as shown in the illustration.

  10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  11. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  12. INSPECT SRS WARNING LIGHT

    Click here

  13. INSPECT TIRE PRESSURE WARNING SYSTEM

    Click here

  14. PERFORM INITIALIZATION

    Click here