COMBINATION METER REMOVAL


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.


    1. for Power Tilt and Power Telescopic Steering Column:


      1. Disable the auto away/return function by changing the customize parameter Click here.

        Note

        Record the current customize parameter setting (whether the auto away/return function is enabled or disabled) in order to restore the current setting after finishing this operation.

        Tech Tips

        Performing the above operation disables the auto away/return function when the engine switch is turned off.

      2. Turn the engine switch on (IG). Operate the tilt and telescopic switch to fully extend and lower the steering column assembly.

      3. Turn the engine switch off and disconnect the cable from the negative (-) battery terminal.

  3. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY


    1. A01G9R9

      Using a moulding remover, disengage the 4 clips and 2 guides.

    2. A01G5IT

      Remove the 2 screws.

    3. A01G8GI

      Disengage the 5 claws and 2 guides and remove the instrument cluster finish panel sub-assembly.

  4. REMOVE COMBINATION METER ASSEMBLY


    1. A01G8JL

      Remove the 2 screws.

    2. A01G9E0

      Disengage the 2 clips.

    3. Disconnect the 2 connectors to remove the combination meter assembly.