METER / GAUGE SYSTEM PRECAUTION

Note

When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected.

System Name See Procedure
Parking Assist Monitor System (w/ Parallel Parking Assist Function)

Click here

Parking Assist Monitor System (w/o Parallel Parking Assist Function)
Power Trunk Lid System

  1. WARNING NOTIFICATION FUNCTION (w/ G-BOOK system with telematics transceiver)

    Note


    • Before performing inspections or repairs which may cause warning messages or DTCs to occur, such as a simulation test or road test, it is necessary to activate warning notification restraint mode so that the G-BOOK center does not recognize the warnings as real ones.

    • Warning notification restraint mode can be entered by using the GTS or operating the switch of the remote touch.

    Tech Tips

    The warning notification function sends a warning ON signal, received from the combination meter assembly via CAN communication, to the G-BOOK center using the G-BOOK device if a warning is displayed in the vehicle due to a vehicle malfunction.


    1. Warning notification restraint mode

      Tech Tips

      To cancel warning notification restraint mode, turn the engine switch off and on (IG) to display the service mode screen and select "Cancel" button on the screen.


      1. Warning notification restraint mode (Using the GTS)


        1. Turn the engine switch off.

        2. Connect the GTS to the DLC3.

        3. Start the engine.

        4. Turn the GTS on.

        5. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

      2. Warning notification restraint mode (Using the switch of the remote touch)


        1. Enter diagnostic mode of the navigation system Click here.