AMBIENT LIGHT (for Rear Door) REMOVAL

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure described below is for the LH side.


  1. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG


    1. A01G862

      Using a moulding remover, disengage the 3 claws and remove the rear door inside handle bezel plug as shown in the illustration.

  2. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL


    1. A01G8H1

      Using a moulding remover, disengage the 2 clips, 4 claws and 2 guides as shown in the illustration.

    2. Disconnect the connector and remove the rear power window regulator switch assembly with rear door armrest base panel.

  3. REMOVE DOOR PULL HANDLE COVER


    1. A01G8OX

      Remove the door pull handle cover.

  4. REMOVE REAR DOOR NO. 1 STIFFENER CUSHION


    1. A01G5KG

      Remove the screw and rear door No. 1 stiffener cushion.

  5. REMOVE COURTESY LIGHT ASSEMBLY


    1. A01G77RE01
      Text in Illustration
      *A for LH Side
      *B for RH Side
      *1 Protective Tape

      Using a screwdriver with its tip wrapped with protective tape, disengage the claw.

    2. Disconnect the connector and remove the courtesy light assembly.

  6. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY


    1. A01G4S2E01
      Text in Illustration
      *1 Protective Tape

      Put protective tape around the rear door panel.

    2. A01G7YL

      Remove the 3 screws.

    3. A01G6Q6

      Using a clip remover, disengage the 8 clips.

    4. A01G5L8E01
      Text in Illustration
      *1 Reference Boss
      *2 Rear Door Inner Glass Weatherstrip

      Pull out the rear door trim board sub-assembly in the direction indicated by the arrow as shown in the illustration.

    5. Disengage the reference boss from the rear door panel.

    6. Using a screwdriver, disengage the 4 claws and disconnect the rear door trim board sub-assembly.

    7. w/ Illumination:


      1. Disconnect the connector.

    8. for 15 Speakers:


      1. Disconnect the connector.

    9. A01G4K7

      Disconnect the rear door lock remote control cable assembly and rear door inside locking cable assembly to remove the rear door trim board sub-assembly.

    10. A01G4O8

      Remove the No. 1 door scuff plate clamp.