ENGINE HOOD COURTESY SWITCH INSTALLATION


  1. INSTALL ENGINE HOOD COURTESY SWITCH (HOOD LOCK ASSEMBLY)


    1. A01G6IJ

      Apply MP grease to the sliding areas of the lock.

    2. Connect the hood lock control cable assembly.

    3. Install the hood lock assembly with the 3 bolts.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

    4. Engage the clamp.

    5. Connect the connector.

  2. INSTALL COOL AIR INTAKE DUCT SEAL


    1. Install the cool air intake duct seal with the 9 clips.

  3. INSPECT HOOD SUB-ASSEMBLY


    1. Check that the clearance measurements of areas "a" through "e" are within each standard range.

      A01G8PSE01
      Standard Clearance
      Area Measurement Area Measurement
      a 2.35 to 5.35 mm (0.0925 to 0.211 in.) b -1.4 to 1.6 mm (-0.0551 to 0.063 in.)
      c 8.70 mm (0.343 in.) d 2.0 to 5.0 mm (0.0787 to 0.197 in.)
      e -1.4 to 1.6 mm (-0.0551 to 0.063 in.) - -

  4. ADJUST HOOD SUB-ASSEMBLY

    Click here