DESCRIPTION
The intrusion sensor (theft warning ultrasonic sensor) conducts self-diagnosis immediately after power is supplied to the sensor (when the theft deterrent system is set).
If a problem is detected in the signals transmitted and received by the intrusion sensor (theft warning ultrasonic sensor), or if the transmission or reception circuits malfunction, the intrusion sensor (theft warning ultrasonic sensor) transmits a signal to the main body ECU (multiplex network body ECU). The main body ECU (multiplex network body ECU) then stores this DTC.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B2761 | Intrusion sensor (theft warning ultrasonic sensor) outputs signal for sensor malfunction |
|
INSPECTION PROCEDURE
Note
If the main body ECU (multiplex network body ECU) is replaced, refer to Service Bulletin.
PROCEDURE
CHECK FOR DTC
Clear the DTCs Click here.
Turn the engine switch on (IG), then off.
Set the theft deterrent system to "ARMED STATE".
Check that the security indicator changes from illuminated to blinking.
Set the theft deterrent system to "DISARMED STATE".
Check for DTCs Click here.
| OK |
|---|
| DTC B2761 is not output. |
| NG |
|
REPLACE INTRUSION SENSOR (THEFT WARNING ULTRASONIC SENSOR) (ROOF CONSOLE BOX ASSEMBLY) Click here |
| OK |
|
USE SIMULATION METHOD TO CHECK Click here
REPLACE INTRUSION SENSOR (THEFT WARNING ULTRASONIC SENSOR) (ROOF CONSOLE BOX ASSEMBLY)
Replace the intrusion sensor (theft warning ultrasonic sensor) (roof console box assembly) Click here.
| NEXT |
|
CHECK FOR DTC
Clear the DTCs Click here.
Turn the engine switch on (IG), then off.
Set the theft deterrent system to "ARMED STATE".
Check that the security indicator changes from illuminated to blinking.
Set the theft deterrent system to "DISARMED STATE".
Check for DTCs Click here.
| OK |
|---|
| DTC B2761 is not output. |
| NG |
|
REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) Click here |
| OK |
|
END (INTRUSION SENSOR (THEFT WARNING ULTRASONIC SENSOR) (ROOF CONSOLE BOX ASSEMBLY) WAS DEFECTIVE)