BLIND SPOT MONITOR MAIN SWITCH INSPECTION


  1. INSPECT BLIND SPOT MONITOR MAIN SWITCH (WARNING CANCELING SWITCH ASSEMBLY)


    1. A01G666E04
      Text in Illustration
      *a

      Component without harness connected

      (Blind Spot Monitor Main Switch (Warning Canceling Switch Assembly))

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      1 (B) - 4 (D) Blind spot monitor main switch is on (not protruding) Below 1 Ω
      1 (B) - 4 (D) Blind spot monitor main switch is off (protruding) 10 kΩ or higher

      If the result is not as specified, replace the blind spot monitor main switch (warning canceling switch assembly).

    2. Check that the switch indicator illuminates.


      1. A01G666E06
        Text in Illustration
        *a

        Component without harness connected

        (Blind Spot Monitor Main Switch (Warning Canceling Switch Assembly))

        Apply battery voltage to the blind spot monitor main switch (warning canceling switch assembly) connector and check operation of the blind spot monitor indicator, as shown in the table below.

        OK
        Connection Condition Specified Condition

        Battery positive (+) → Terminal 1 (B)

        Battery negative (-) → Terminal 5 (E)

        		 Blind spot monitor main switch is on (not protruding) Blind spot monitor indicator illuminates

        Battery positive (+) → Terminal 1 (B)

        Battery negative (-) → Terminal 5 (E)

        		 Blind spot monitor main switch is off (protruding) Blind spot monitor indicator not illuminate

        If the result is not as specified, replace the blind spot monitor main switch (warning canceling switch assembly).

    3. Check that the switch illuminates.


      1. A01G666E05
        Text in Illustration
        *a

        Component without harness connected

        (Blind Spot Monitor Main Switch (Warning Canceling Switch Assembly))

        Apply battery voltage to the blind spot monitor main switch (warning canceling switch assembly) and check that the switch illuminates.

        OK
        Connection Specified Condition

        Battery positive (+) → Terminal 3 (ILL+)

        Battery negative (-) → Terminal 2 (ILL-)

        		 Illuminates

        If the result is not as specified, replace the blind spot monitor main switch (warning canceling switch assembly).