DESCRIPTION
This DTC is stored when the rear television camera assembly judges that the back camera initial setting has not been memorized (rear television camera assembly optical axis adjustment (back camera position setting) is incomplete).
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1691 | Back camera initial setting has not been memorized (rear television camera assembly optical axis adjustment (back camera position setting) is incomplete) |
|
INSPECTION PROCEDURE
Note
If the cable was disconnected from and reconnected to the negative (-) battery terminal, the estimated course lines may not be displayed on the image of the area behind the vehicle. In this case, perform "Correct the Steering Angle Neutral Point" Click here.
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed Click here.
PROCEDURE
PERFORM CALIBRATION
Perform the following procedure depending on the memory conditions to register the vehicle information into the rear television camera assembly.
Rear television camera assembly optical axis adjustment (back camera position setting) Click here.
| NEXT |
|
CHECK DTC OUTPUT
Clear the DTCs Click here.
Recheck for DTCs and check that no DTCs are output Click here.
Tech Tips
If DTC C1691 is output, perform the rear television camera assembly optical axis adjustment (back camera position setting) again.
If DTC C1691 is still output after performing the rear television camera assembly optical axis adjustment 3 times, replace the rear television camera assembly.
| Result | ||||||
|---|---|---|---|---|---|---|
|
| B |
|
END |
| A |
|
REPLACE REAR TELEVISION CAMERA ASSEMBLY Click here