PARKING ASSIST MONITOR SYSTEM (w/o Parallel Parking Assist Function) DATA LIST / ACTIVE TEST


  1. DATA LIST

    Note

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    Tech Tips

    Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


    1. Connect the GTS to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Chassis / Advanced Parking Guidance/Parking Assist Monitor / Data List.

    5. Read the Data List according to the display on the GTS.

    Advanced Parking Guidance/Parking Assist Monitor
    Tester Display Measurement Item/Range Normal Condition Diagnostic Note
    Destination Data Check Verification of destination data/OK or NG

    OK: Data verification normal

    NG: Data verification abnormal

    -
    EEPROM Status (Initial read) Rear television camera assembly information/OK or NG

    OK: Rear television camera assembly normal

    NG: Rear television camera assembly abnormal

    -
    CPU Communication Status Rear television camera assembly information/OK or NG

    OK: Rear television camera assembly normal

    NG: Rear television camera assembly abnormal

    -
    ASIC Output Status Output condition of video signal/OK or NG

    OK: Output condition of video signal normal

    NG: Output condition of video signal abnormal

    -
    Wheel Speed Sensor (4wheel) Vehicle speed signal from speed sensor/OK or NG

    OK: Speed signal normal

    NG: Speed signal abnormal

    -
    Parking Assist Function of Camera Rear television camera assembly condition/Valid or Invalid

    Valid: Rear television camera assembly operating

    Invalid: Rear television camera assembly not operating

    -
    Number of DTC Number of stored trouble codes/min.: 0, max.: 255 Number of DTCs will be displayed -