PARKING ASSIST MONITOR SYSTEM (w/ Parallel Parking Assist Function) HOW TO PROCEED WITH TROUBLESHOOTING

Tech Tips


  • Use the following procedure to troubleshoot the parking assist monitor system.

  • *: Use the GTS.


  1. VEHICLE BROUGHT TO WORKSHOP


    NEXT

  2. INSPECT BATTERY VOLTAGE


    1. Measure the battery voltage.

      Standard Voltage
      11 to 14 V

      If the voltage is below 11 V, replace or recharge the battery before proceeding to the next step.


      NEXT

  3. CHECK IF SAME SYMPTOM APPEARS IN OTHER SYSTEM


    1. Refer to Navigation System Click here.*1

    2. Refer to Audio and Visual System (w/ Multi-display) Click here.*2


      • *1: w/ Navigation System

      • *2: w/o Navigation System

      Result
      Result Proceed to
      Symptom does not occur A
      Symptom appears (w/ Navigation System) B
      Symptom appears (w/o Navigation System) C

      B

      GO TO NAVIGATION SYSTEM Click here

      C

      GO TO AUDIO AND VISUAL SYSTEM (w/ Multi-display) Click here

      A

  4. CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*


    1. Use the GTS to check if the CAN communication system is functioning normally Click here.

      Result
      Result Proceed to
      CAN DTCs are not output. (w/ Power Trunk Lid System) A
      CAN DTCs are not output. (w/o Power Trunk Lid System) B
      CAN DTCs are output. C

      B

      Go to step 6
      C

      GO TO CAN COMMUNICATION SYSTEM Click here

      A

  5. CHECK FOR DTC (LUGGAGE COMPARTMENT DOOR CLOSER SYSTEM)*


    1. Check for DTCs Click here.

      Result
      Result Proceed to
      Luggage compartment door closer system DTCs are not output. A
      Luggage compartment door closer system DTCs are output. B

      B

      GO TO LUGGAGE COMPARTMENT DOOR CLOSER SYSTEM Click here

      A

  6. CHECK FOR DTC (PARKING ASSIST MONITOR SYSTEM)*


    1. Check for DTCs and note any codes that are output Click here.

    2. Clear the DTCs Click here.

    3. Recheck for DTCs. Try to prompt the DTC by simulating the original activity that the DTC suggests.

      Note

      The multi-media module receiver assembly outputs DTCs for the following systems. When DTCs other than those in Diagnostic Trouble Code Chart for the parking assist monitor system are output, refer to Diagnostic Trouble Code Chart for the relevant system.

      System Proceed to
      Navigation System*1

      Click here

      Audio and Visual System (w/ Multi-display)*2

      Click here

      G-BOOK System (w/ Telematics Transceiver)

      Click here


      • *1: w/ Navigation System

      • *2: w/o Navigation System

      Result
      Result Proceed to
      No DTCs are output. A
      Parking assist monitor system DTCs are output. B
      Navigation system DTCs are output (w/ Navigation System) C
      Audio and visual system (w/ Multi-display) DTCs are output (w/o Navigation System) D
      DTCs for G-BOOK system (w/ Telematics Transceiver) are output. E

      B

      Go to step 9
      C

      GO TO NAVIGATION SYSTEM Click here

      D

      GO TO AUDIO AND VISUAL SYSTEM (w/ Multi-display) Click here

      E

      GO TO G-BOOK SYSTEM Click here

      A

  7. PROBLEM SYMPTOMS TABLE


    1. Refer to the Problem Symptoms Table Click here.

      Result
      Result Proceed to
      Fault is not listed in Problem Symptoms Table A
      Fault is listed in Problem Symptoms Table B

      B

      Go to step 9
      A

  8. OVERALL ANALYSIS AND TROUBLESHOOTING*


    1. Diagnosis System Click here

    2. Terminals of ECU Click here

    3. Data List / Active Test Click here


      NEXT

  9. ADJUST, REPAIR OR REPLACE


    NEXT

  10. CONFIRMATION TEST


    NEXT
    END