NAVIGATION RECEIVER INSTALLATION


  1. PRECAUTION (w/ G-BOOK System)

    Note

    When installing the hard disk drive, eliminate static electricity by touching the vehicle body to prevent components from being damaged.

  2. INSTALL MULTI-MEDIA MODULE RECEIVER ASSEMBLY

  3. INSTALL HARD DISK DRIVE (w/ G-BOOK System)


    1. A01G7R8

      Insert the hard disk drive in the direction shown by the arrow in the illustration to install it.

    2. Install the cover with the 3 screws.

    3. Install the claw with the screw.

  4. INSTALL NO. 2 RADIO BRACKET


    1. Install the No. 2 radio bracket with the 4 screws.

  5. INSTALL NO. 1 RADIO BRACKET


    1. Install the No. 1 radio bracket with the 4 screws.

  6. INSTALL MULTI-MEDIA MODULE RECEIVER ASSEMBLY WITH BRACKET


    1. Connect each connector.

    2. Engage the 2 clips and 2 claws to the vehicle body to temporarily install the multi-media module receiver assembly with bracket.

    3. Install the multi-media module receiver assembly with bracket with the 4 bolts.

  7. INSTALL LOWER CENTER INSTRUMENT PANEL FINISH PANEL


    1. A01G96C

      Engage the 2 claws and 5 clips to install the lower center instrument panel finish panel as shown in the illustration.

  8. INSTALL NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY


    1. Connect the connector.

    2. Engage the 11 claws and clip to install the No. 2 instrument panel register assembly.

      A01G5L1

      Note

      When installing the No. 2 instrument panel register assembly, check that the wire harness is not caught between the No. 2 instrument panel register assembly and duct.

  9. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL GARNISH


    1. Connect the connector.

    2. Engage the 10 claws and 2 clips to install the center instrument cluster finish panel garnish.

      A01G9I0

  10. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY


    1. Engage the 5 claws and 2 guides.

    2. Install the 2 screws.

    3. A01G8Q8

      Engage the 4 clips and 2 guides to install the instrument cluster finish panel sub-assembly.

  11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  12. INSPECT HARD DISK DRIVE (w/ G-BOOK System)

    Click here

  13. REPLACED OPERATION (w/ Parking Assist Monitor System)

    w/ Parallel Parking Assist Function: Click here

    w/o Parallel Parking Assist Function: Click here

  14. CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM (for Power Tilt and Power Telescopic Steering Column)

    Note

    Reset the auto away/return function setting to the previous condition by changing the customize parameter Click here.