POWER STEERING ECU (for Power Tilt and Power Telescopic Steering Column) REMOVAL


  1. REMOVE STEERING COLUMN ASSEMBLY

    Click here

  2. REMOVE STEERING LOCK ACTUATOR ASSEMBLY


    1. Using a center punch, mark the center of the 2 tapered-head bolts.

    2. Using a 3 to 4 mm (0.118 to 0.157 in.) diameter drill bit, drill a hole in each tapered-head bolt.

    3. for Manual Tilt and Manual Telescopic Steering Column:


      1. Secure the steering column assembly in a vise using aluminum plates.

        Note

        Do not overtighten the vise.

      2. A01G491

        Using a screw extractor, remove each tapered-head bolt, and then remove the steering lock actuator assembly from the steering column assembly.

    4. for Power Tilt and Power Telescopic Steering Column:


      1. A01G95Y

        Using a screw extractor, remove each tapered-head bolt, and then remove the steering lock actuator assembly from the steering column assembly.

  3. REMOVE POWER STEERING ECU PROTECTOR


    1. A01G9MZ

      Remove the power steering ECU protector from the power steering ECU with motor assembly.

  4. DISCONNECT ECU WIRE SUB-ASSEMBLY


    1. A01G6PI

      Disconnect the 2 connectors from the power steering ECU with motor assembly.

  5. REMOVE POWER STEERING ECU WITH MOTOR ASSEMBLY


    1. A01G7OD

      Disconnect the connector from the power steering ECU with motor assembly.

    2. A01G7KD

      Remove the 3 bolts and power steering ECU with motor assembly from the electric power steering column sub-assembly.

    3. A01G4NZ

      Remove the electric power steering motor shaft spacer from the electric power steering column sub-assembly.

    4. A01G6G2

      Remove the electric power steering motor shaft damper from the electric power steering column sub-assembly.