PARKING BRAKE PEDAL (for RHD) REMOVAL


  1. TURN FRONT WHEELS TO FACE STRAIGHT AHEAD

  2. REMOVE FRONT WHEEL RH

  3. REMOVE SHIFT LEVER SUPPORT

    Tech Tips

    Use the same procedure as for LHD.


  4. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

    Click here

  5. REMOVE FLOOR CARPET BRACKET LH


    1. A01G47K

      Remove the 2 clips.

    2. Disengage the 2 guides to remove the floor carpet bracket LH.

  6. REMOVE AIRBAG SENSOR ASSEMBLY


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Turn back the carpet.

    4. A01G5XI

      Disconnect the connectors from the airbag sensor assembly as shown in the illustration.

      Note

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.

    5. Remove the 3 bolts and airbag sensor assembly.

  7. REMOVE COMBINATION METER ASSEMBLY

    Tech Tips

    Use the same procedure as for LHD Click here.

  8. REMOVE NO. 2 AIR DUCT SUB-ASSEMBLY


    1. A01G9P2

      Remove the bolt.

    2. Disengage the 2 claws to remove the No. 2 air duct sub-assembly.

  9. SEPARATE STEERING INTERMEDIATE SHAFT ASSEMBLY

    Tech Tips

    Use the same procedure as for LHD Click here.

  10. REMOVE STEERING INTERMEDIATE SHAFT ASSEMBLY

    Tech Tips

    Use the same procedure as for LHD Click here.

  11. LOOSEN ADJUSTING NUT


    1. A01G80TE01
      Text in Illustration
      *1 Lock Nut
      *2 Adjusting Nut

      Remove the lock nut and loosen the adjusting nut.

  12. SEPARATE NO. 4 PARKING BRAKE CABLE ASSEMBLY


    1. A01G79TE01
      Text in Illustration
      *a Turn
      *b Hold

      Separate the No. 4 parking brake cable assembly from the parking brake control pedal assembly as shown in the illustration.

  13. REMOVE PARKING BRAKE CONTROL PEDAL ASSEMBLY


    1. A01G8KM

      Remove the clip from the No. 1 parking brake cable assembly.

    2. Remove the bolt and separate the No. 1 parking brake cable assembly.

    3. A01G4E9

      Disconnect the parking brake switch connector.

    4. A01G4EN

      Remove the bolt, 2 nuts and parking brake control pedal assembly.