REAR BRAKE FLEXIBLE HOSE INSTALLATION

Note


  • Because the left and right rear flexible hoses are not interchangeable, verify the part number when installing the flexible hoses.

  • If the hoses are to be reused, connect them after checking the identification marks placed when each hose was disconnected.

Tech Tips


  • Use the same procedure for the LH side and RH side.

  • The following procedure is for the LH side.


  1. INSTALL REAR FLEXIBLE HOSE


    1. A01G9F5E02
      Text in Illustration
      *a Lock Hole

      Connect the rear flexible hose to the rear disc brake cylinder assembly with a new union bolt and a new gasket.

      Torque:
      33 N*m  { 340 kgf*cm, 25 ft.*lbf }

      Note

      Install the flexible hose lock securely into the lock hole in the disc brake cylinder.

    2. A01G6M7E02
      Text in Illustration
      *1 Brake Line
      *2 Clip
      *3 Bolt
      *a Identification Mark

      Install a new clip.

      Note


      • Install the clip as far as it will go.

      • When installing the rear flexible hose, face the identification mark to the outside of the vehicle and minimize twisting of the hose.

    3. Install the rear flexible hose with the bolt.

      Torque:
      19 N*m  { 192 kgf*cm, 14 ft.*lbf }

    4. Using a union nut wrench, connect the brake line to the rear flexible hose while holding the rear flexible hose with a wrench.

      Torque:
      15 N*m  { 155 kgf*cm, 11 ft.*lbf }

      Note


      • Do not bend or damage the brake line.

      • Do not allow any foreign matter such as dirt or dust to enter the brake line from the connecting points.

      • Use the formula to calculate special torque values for situations where the union nut wrench is combined with a torque wrench Click here.

  2. BLEED BRAKE LINE

    Click here

  3. INSTALL REAR WHEEL

    Torque:
    103 N*m  { 1049 kgf*cm, 76 ft.*lbf }