PARKING BRAKE PEDAL (for LHD) REMOVAL


  1. REMOVE SHIFT LEVER SUPPORT


  2. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

    Click here

  3. REMOVE FLOOR CARPET BRACKET RH


    1. A01G5G8

      Remove the 2 clips.

    2. Disengage the 2 guides to remove the floor carpet bracket RH.

  4. REMOVE AIRBAG SENSOR ASSEMBLY


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Turn back the carpet.

    4. A01G5XI

      Disconnect the connectors from the airbag sensor assembly as shown in the illustration.

      Note

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.

    5. Remove the 3 bolts and airbag sensor assembly.

  5. LOOSEN ADJUSTING NUT


    1. A01G5VXE01
      Text in Illustration
      *1 Lock Nut
      *2 Adjusting Nut

      Remove the lock nut and loosen the adjusting nut.

  6. SEPARATE NO. 4 PARKING BRAKE CABLE ASSEMBLY


    1. A01G79TE01
      Text in Illustration
      *a Turn
      *b Hold

      Separate the No. 4 parking brake cable assembly from the parking brake pedal sub-assembly as shown in the illustration.

  7. REMOVE PARKING BRAKE PEDAL SUB-ASSEMBLY


    1. Turn back the floor carpet.

    2. A01G7SD

      Remove the clip from the No. 1 parking brake cable assembly.

    3. Remove the bolt and 2 nuts, and separate the No. 1 parking brake cable assembly.

    4. A01G6RK

      Disconnect the parking brake switch assembly connector.

    5. A01G97C

      Remove the bolt, 2 nuts and parking brake pedal sub-assembly.