REAR SPEED SENSOR REMOVAL

Tech Tips


  • Use the same procedure for the LH side and RH side.

  • The following procedure is for the LH side.

  • If the sensor rotor needs to be replaced, replace the rear axle hub and bearing assembly.

  • The rear speed sensor is a component of the rear axle hub and bearing assembly. If the rear speed sensor malfunctions, replace the rear axle hub and bearing assembly.


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE REAR WHEEL

  4. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY


    1. A01G5UE

      Remove the bolt and separate the rear flexible hose from the rear shock absorber.

    2. Remove the 2 bolts, and separate the rear disc brake caliper assembly.

      Note

      Use wire or an equivalent tool to keep the rear disc brake caliper from hanging down by the flexible hose.

  5. REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG


    1. Remove the parking brake shoe adjusting hole plug.

  6. REMOVE REAR DISC


    1. A01G62KE01
      Text in Illustration
      *a Matchmark

      Put matchmarks on the rear disc and the rear axle hub.

    2. A01G8YW

      Release the parking brake and remove the rear disc.

      Tech Tips

      If the disc cannot be removed easily, use a screwdriver to turn the shoe adjuster as shown in the illustration in order to contract the parking brake shoes.

  7. DISCONNECT SKID CONTROL SENSOR WIRE


    1. A01G4I2

      Using a screwdriver, disconnect the connector from the rear speed sensor.

      Note

      Be careful not to damage the rear speed sensor.

  8. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY


    1. Remove the rear axle hub and bearing assembly Click here.

      Tech Tips


      • The rear speed sensor is a component of the rear axle hub and bearing assembly. If the rear speed sensor malfunctions, replace the rear axle hub and bearing assembly.

      • If the sensor rotor needs to be replaced, replace the rear axle hub and bearing assembly.