BRAKE ACTUATOR REMOVAL


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. SEPARATE SUCTION PIPE CLAMP


    1. A01G7EY

      Disengage the suction pipe clamp to separate it from the brake actuator bracket assembly.

  4. REMOVE BRAKE ACTUATOR WITH BRACKET


    1. A01G7EE

      Release the lock lever and disconnect the connector from the brake actuator assembly.

      Text in Illustration
      A01G8AH Release the lock lever
      A01G47H Disconnect the connector
    2. A01G8VGE01
      Text in Illustration
      *a From 1st Chamber of Master Cylinder Sub-assembly
      *b From 2nd Chamber of Master Cylinder Sub-assembly
      *c To Front Wheel Cylinder Assembly LH
      *d To Rear Wheel Cylinder Assembly RH
      *e To Rear Wheel Cylinder Assembly LH
      *f To Front Wheel Cylinder Assembly RH

      Using a union nut wrench, disconnect the 6 brake lines from the brake actuator assembly.

    3. Use tags or make a memo to identify the places to reconnect the lines.

    4. A01G6PU

      Remove the 3 bolts and brake actuator with bracket from the vehicle body.

      Note

      Do not damage the brake lines, suction pipe sub-assembly or wire harness.

  5. REMOVE BRAKE ACTUATOR ASSEMBLY


    1. A01G4YT

      Remove the 3 bolts and brake actuator assembly from the brake actuator bracket assembly.