REAR STABILIZER BAR INSTALLATION


  1. INSTALL REAR STABILIZER BUSHING (for LH Side)


    1. A01G94SE01
      Text in Illustration
      *a Stopper Ring
      *b Cutout
      A01G8AH Front of the Vehicle
      A01G47H Outside of the Vehicle

      Install the rear stabilizer bushing to the outside of the stopper ring on the rear stabilizer bar as shown in the illustration.

      Note

      Install the rear stabilizer bushing so that the cutout faces rearward.

  2. INSTALL REAR STABILIZER BUSHING (for RH Side)

    Tech Tips

    Perform the same procedure as the LH side.

  3. INSTALL REAR NO. 1 STABILIZER BAR BRACKET (for LH Side)


    1. A01G4AA

      Install the rear No. 1 stabilizer bar bracket to the rear stabilizer bar.

      Text in Illustration
      A01G8AH Front of the Vehicle

      Note

      Be sure to install the rear No. 1 stabilizer bar bracket in the correct direction.

  4. INSTALL REAR NO. 1 STABILIZER BAR BRACKET (for RH Side)

    Tech Tips

    Perform the same procedure as the LH side.

  5. INSTALL REAR NO. 2 STABILIZER BAR BRACKET (for LH Side)


    1. A01G6FZ

      Install the rear No. 2 stabilizer bar bracket to the rear stabilizer bar.

  6. INSTALL REAR NO. 2 STABILIZER BAR BRACKET (for RH Side)

    Tech Tips

    Perform the same procedure as the LH side.

  7. INSTALL REAR STABILIZER BAR


    1. A01G8M9

      Install the rear stabilizer bar with the 4 nuts.

      Text in Illustration
      A01G8AH Nut
      A01G47H Front of the Vehicle
      Torque:
      18 N*m  { 184 kgf*cm, 13 ft.*lbf }

  8. INSTALL REAR STABILIZER LINK ASSEMBLY LH


    1. Install the rear stabilizer link assembly LH to the rear shock absorber with coil spring with the nut.

      Torque:
      39 N*m  { 400 kgf*cm, 29 ft.*lbf }

      If the ball joint turns together with the nut, use a hexagon wrench to hold the stud.

    2. Install the rear stabilizer link assembly LH to the rear stabilizer bar with the nut.

      Torque:
      39 N*m  { 400 kgf*cm, 29 ft.*lbf }

      If the ball joint turns together with the nut, use a hexagon wrench to hold the stud.

  9. INSTALL REAR STABILIZER LINK ASSEMBLY RH

    Tech Tips

    Perform the same procedure as the LH side.

  10. INSTALL NO. 2 FLOOR UNDER COVER


    1. Install the No. 2 floor under cover with the 2 bolts, 3 nuts and 2 clips.

      Torque:
      4.0 N*m  { 41 kgf*cm, 35 in.*lbf }

  11. INSTALL NO. 1 FLOOR UNDER COVER


    1. Install the No. 1 floor under cover with the 2 bolts, 3 nuts and 2 clips.

      Torque:
      4.0 N*m  { 41 kgf*cm, 35 in.*lbf }

  12. INSTALL REAR WHEELS

    Torque:
    103 N*m  { 1049 kgf*cm, 76 ft.*lbf }