REAR LOWER ARM (for No. 2 Arm) INSTALLATION

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.


  1. TEMPORARILY TIGHTEN REAR NO. 2 SUSPENSION ARM ASSEMBLY


    1. A01G7MM

      Temporarily tighten the rear No. 2 suspension arm assembly (inner side) to the rear suspension member sub-assembly with the bolt.

      Text in Illustration
      A01G8AH Bolt
      A01G7F9 Paint Mark

      Tech Tips

      Ensure that the paint mark faces the rear of the vehicle.

  2. CONNECT REAR NO. 2 SUSPENSION ARM ASSEMBLY


    1. Connect the rear No. 2 suspension arm assembly (outer side) to the rear axle carrier sub-assembly with the bolt and nut.

      Note

      When temporarily tightening the bolt, keep the nut from rotating.

      Tech Tips

      Insert the bolt from the rear of the vehicle.

  3. STABILIZE SUSPENSION


    1. A01G4REE01
      Text in Illustration
      *1 Wooden Block

      Jack up the rear axle carrier sub-assembly, placing a wooden block under it to avoid damage. Apply load to the suspension so that the installed bolt of the rear No. 1 suspension arm assembly (inner side) is horizontally aligned with the center of the rear axle hub.

      CAUTION:

      Do not jack up the rear axle carrier sub-assembly too high as the vehicle may fall.

      Note


      • When jacking up the rear axle carrier sub-assembly, be sure to jack it up slowly.

      • Make sure to perform this operation with the vehicle kept as low as possible.

  4. FULLY TIGHTEN REAR NO. 2 SUSPENSION ARM ASSEMBLY


    1. A01G4DHE01
      Text in Illustration
      *a Fulcrum Length

      Using SST, fully tighten the rear No. 2 suspension arm assembly (inner side) with the bolt.

      SST
      09961-00950
      Torque:
      without SST
      100 N*m  { 1020 kgf*cm, 74 ft.*lbf }
      with SST
      72 N*m  { 731 kgf*cm, 53 ft.*lbf }

      Note


      • Use a torque wrench with a fulcrum length of 380 mm (1.25 ft.).

      • This torque value is effective when SST is parallel to the torque wrench.

    2. A01G9JM

      Fully tighten the rear No. 2 suspension arm assembly (outer side) with the bolt.

      Torque:
      100 N*m  { 1020 kgf*cm, 74 ft.*lbf }

      Note

      Since a stopper nut is used, fully tighten the bolt.

  5. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY (w/ Height Control Sensor)

    Click here

    Tech Tips

    It is necessary to install the rear height control sensor sub-assembly when installing the rear No. 2 suspension arm assembly RH.

  6. INSTALL CENTER EXHAUST PIPE ASSEMBLY


  7. INSTALL REAR WHEEL

    Torque:
    103 N*m  { 1049 kgf*cm, 76 ft.*lbf }

  8. INSPECT AND ADJUST REAR WHEEL ALIGNMENT

    Click here