REAR LOWER ARM (for No. 2 Arm) REMOVAL

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.


  1. REMOVE REAR WHEEL

  2. REMOVE CENTER EXHAUST PIPE ASSEMBLY


  3. REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY (w/ Height Control Sensor)

    Click here

    Tech Tips

    It is necessary to remove the rear height control sensor sub-assembly when separating the rear No. 2 suspension arm assembly RH.

  4. SEPARATE REAR NO. 2 SUSPENSION ARM ASSEMBLY


    1. A01G5XH

      Remove the bolt and nut, and separate the rear No. 2 suspension arm assembly (outer side) from the rear axle carrier sub-assembly.

      Note

      When removing the bolt, keep the nut from rotating.

  5. REMOVE REAR NO. 2 SUSPENSION ARM ASSEMBLY


    1. A01G7MM

      Remove the bolt and rear No. 2 suspension arm assembly from the rear suspension member sub-assembly.