TRANSMISSION CONTROL CABLE REMOVAL


  1. REMOVE COOL AIR INTAKE DUCT SEAL


    1. A01G7XF

      Remove the 9 clips and cool air intake duct seal.

  2. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    1. A01G6L6

      Lift the rear of the No. 1 engine cover sub-assembly to detach it from the 2 pins.

    2. Lift the front of the No. 1 engine cover sub-assembly to detach the it from the pin and remove it.

      Note

      Attempting to disengage both front and rear pins at the same time may cause the No. 1 engine cover sub-assembly to break.

  3. REMOVE INLET AIR CLEANER ASSEMBLY


    1. A01G7TY

      Remove the 2 bolts and inlet air cleaner assembly.

  4. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    1. A01G6TI

      Disconnect the vacuum switching valve assembly from the air cleaner cap sub-assembly.

    2. A01G9UT

      Disconnect the mass air flow meter connector and separate the 2 wire harness clamps from the air cleaner cap sub-assembly.

    3. A01G7KC

      Separate the fuel vapor feed hose from the air cleaner cap sub-assembly.

    4. A01G481

      Disconnect the ventilation hose from the cylinder head cover.

    5. A01G7ME

      Loosen the hose clamp and disconnect the air cleaner cap sub-assembly from the throttle with motor body assembly.

    6. A01G64N

      Release the 2 clamps and remove the air cleaner cap sub-assembly.

  5. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

  6. REMOVE AIR CLEANER CASE SUB-ASSEMBLY


    1. A01G6IM

      Disconnect the wire harness clamp.

    2. Remove the 2 bolts and air cleaner case sub-assembly.

  7. REMOVE AIRBAG SENSOR ASSEMBLY

    Click here

  8. REMOVE ACCELERATOR PEDAL SENSOR ASSEMBLY

    Note


    • Avoid physical shock to the accelerator pedal sensor assembly.

    • Do not disassemble the accelerator pedal sensor assembly.

    • The accelerator pedal sensor assembly does not require lubrication.

    • Do not apply oil or other lubricants to the accelerator pedal sensor assembly. If applied, the accelerator pedal sensor assembly must be replaced.


    1. A01G7LGE01
      Text in Illustration
      *A for LHD
      *B for RHD

      Disconnect the accelerator pedal sensor assembly connector.

    2. Remove the 2 bolts and accelerator pedal sensor assembly.

  9. DISCONNECT NO. 1 PARKING BRAKE CABLE ASSEMBLY


    1. Turn back the floor carpet.

    2. A01G93Z

      Remove the bolt and nut, and disconnect the No. 1 parking brake cable assembly from the body.

  10. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY


    1. Move the shift lever to N.

    2. A01G6FF

      Disconnect the end of the transmission control cable assembly from the lower shift lever assembly.

    3. Disengage the 2 claws and disconnect the transmission control cable assembly from the lower shift lever assembly.

    4. A01G476

      Disconnect the wire harness clamp from the wire harness clamp bracket.

    5. A01G8P1

      Remove the nut and disconnect the transmission control cable assembly from the transmission control shaft lever.

    6. Remove the clip and disconnect the transmission control cable assembly from the No. 1 transmission control cable bracket.

    7. A01G94L

      Turn back the dash panel insulator.

    8. Remove the 2 bolts and pull out the transmission control cable assembly from the body.