COMBINATION SWITCH INSPECTION


  1. INSPECT INTEGRATION CONTROL AND PANEL ASSEMBLY


    1. Inspect ECO mode switch


      1. A01G90SE06
        Text in Illustration
        *a

        Component without harness connected

        (Integration Control and Panel Assembly)

        Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        4 (ECU) - 5 (E) ECO mode switch turned and held at ECO position Below 10 Ω
        ECO mode switch not turned 10 kΩ or higher

        If the result is not as specified, replace the integration control and panel assembly.

    2. Inspect NORMAL mode switch


      1. A01G90SE07
        Text in Illustration
        *a

        Component without harness connected

        (Integration Control and Panel Assembly)

        Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        2 (B) - 5 (E) NORMAL mode switch pushed and held Below 10 Ω
        NORMAL mode switch not pushed 10 kΩ or higher

        If the result is not as specified, replace the integration control and panel assembly.

    3. Inspect SPORT mode switch


      1. A01G90SE08
        Text in Illustration
        *a

        Component without harness connected

        (Integration Control and Panel Assembly)

        Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        3 (P) - 5 (E) SPORT mode switch turned and held at SPORT position Below 10 Ω
        SPORT mode switch not turned 10 kΩ or higher

        If the result is not as specified, replace the integration control and panel assembly.

    4. Inspect VSC off switch


      1. A01G90SE10
        Text in Illustration
        *a

        Component without harness connected

        (Integration Control and Panel Assembly)

        Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        7 (+) - 5 (E) VSC off switch pushed and held Below 10 Ω
        VSC off switch not pushed 10 kΩ or higher

        If the result is not as specified, replace the integration control and panel assembly.

    5. Inspect illumination


      1. A01G9ERE01
        Text in Illustration
        *a

        Component without harness connected

        (Integration Control and Panel Assembly)
        *b Integration Control and Panel Assembly Illumination

        Apply battery voltage between the terminals of the integration control and panel assembly switch, and check the illumination condition of the integration control and panel assembly.

        Standard
        Measurement Condition Specified Condition
        Battery positive (+) → 8 (ILL+) Battery negative (-) → 6 (ILL-) Illuminates

        If the result is not as specified, replace the integration control and panel assembly.