TCM REMOVAL

Note

If automatic transaxle parts are replaced, refer to Parts Replacement Compensation Table to determine if any additional operations are necessary Click here.


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE COOL AIR INTAKE DUCT SEAL


    1. A01G7XF

      Remove the 9 clips and cool air intake duct seal.

  3. REMOVE INLET NO. 2 AIR CLEANER


    1. A01G8C4

      Disconnect the 2 wire harness clamps and vacuum hose clamp.

    2. Remove the 2 bolts and inlet No. 2 air cleaner.

  4. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    1. A01G55V

      Disconnect the mass air flow meter connector and wire harness clamp.

    2. A01G6Q3

      Disconnect the 3 hoses.

    3. Disconnect the ventilation hose from the air cleaner cap sub-assembly.

    4. A01G67K

      Loosen the hose clamp and separate the air cleaner cap sub-assembly from the throttle with motor body assembly.

    5. Release the 2 clamps and remove the air cleaner cap sub-assembly.

  5. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

  6. REMOVE AIR CLEANER CASE SUB-ASSEMBLY


    1. A01G9DG

      Disconnect the 3 wire harness clamps, connector, vacuum hose and No. 1 fuel vapor feed hose.

    2. Remove the 2 bolts and air cleaner case sub-assembly.

  7. REMOVE BATTERY


    1. A01G966

      Disconnect the positive (+) cable from the positive (+) battery terminal.

    2. Loosen the nut and remove the bolt.

    3. Remove the battery clamp, battery and battery tray.

  8. REMOVE INLET NO. 1 AIR CLEANER


    1. A01G4LL

      Disengage the pin and remove the inlet No. 1 air cleaner.

  9. REMOVE TCM


    1. A01G5RX

      Turn the lock lever and disconnect the connector from the TCM.

    2. A01G4LV

      Remove the 2 bolts and TCM from the automatic transaxle assembly.