TRANSMISSION CONTROL CABLE REMOVAL


  1. REMOVE COOL AIR INTAKE DUCT SEAL


    1. A01G7XF

      Remove the 9 clips and cool air intake duct seal.

  2. REMOVE INLET NO. 2 AIR CLEANER


    1. A01G8C4

      Disconnect the 2 wire harness clamps and vacuum hose clamp.

    2. Remove the 2 bolts and inlet No. 2 air cleaner.

  3. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    1. A01G55V

      Disconnect the mass air flow meter connector and wire harness clamp.

    2. A01G6Q3

      Disconnect the 3 hoses.

    3. Disconnect the ventilation hose from the air cleaner cap sub-assembly.

    4. A01G67K

      Loosen the hose clamp and separate the air cleaner cap sub-assembly from the throttle with motor body assembly.

    5. Release the 2 clamps and remove the air cleaner cap sub-assembly.

  4. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

  5. REMOVE AIR CLEANER CASE SUB-ASSEMBLY


    1. A01G9DG

      Disconnect the 3 wire harness clamps, connector, vacuum hose and No. 1 fuel vapor feed hose.

    2. Remove the 2 bolts and air cleaner case sub-assembly.

  6. REMOVE AIRBAG SENSOR ASSEMBLY

    Click here

  7. REMOVE ACCELERATOR PEDAL SENSOR ASSEMBLY

    Note


    • Avoid physical shock to the accelerator pedal sensor assembly.

    • Do not disassemble the accelerator pedal sensor assembly.

    • The accelerator pedal sensor assembly does not require lubrication.

    • Do not apply oil or other lubricants to the accelerator pedal sensor assembly. If applied, the accelerator pedal sensor assembly must be replaced.


    1. A01G7LGE01
      Text in Illustration
      *A for LHD
      *B for RHD

      Disconnect the accelerator pedal sensor assembly connector.

    2. Remove the 2 bolts and accelerator pedal sensor assembly.

  8. DISCONNECT NO. 1 PARKING BRAKE CABLE ASSEMBLY


    1. Turn back the floor carpet.

    2. A01G93Z

      Remove the bolt and nut, and disconnect the No. 1 parking brake cable assembly from the body.

  9. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY


    1. Move the shift lever to N.

    2. A01G6FF

      Disconnect the end of the transmission control cable assembly from the lower shift lever assembly.

    3. Disengage the 2 claws and disconnect the transmission control cable assembly from the lower shift lever assembly.

    4. A01G476

      Disconnect the wire harness clamp from the wire harness clamp bracket.

    5. A01G8P1

      Remove the nut and disconnect the transmission control cable assembly from the transmission control shaft lever.

    6. Remove the clip and disconnect the transmission control cable assembly from the No. 1 transmission control cable bracket.

    7. A01G94L

      Turn back the dash panel insulator.

    8. Remove the 2 bolts and pull out the transmission control cable assembly from the body.