DYNAMIC RADAR CRUISE CONTROL SYSTEM, Diagnostic DTC:P0503

DTC Code DTC Name
P0503 Vehicle Speed Sensor "A" Intermittent / Erratic / High

DESCRIPTION

If a malfunction (a rapid change in vehicle speed) in the vehicle speed signal being output from the skid control ECU (brake actuator assembly) is detected while the dynamic radar cruise control is operating, the ECM determines that there is a momentary interruption or noise, and stores a DTC.

DTC No. DTC Detection Condition Trouble Area
P0503 A momentary interruption and noise are detected when a rapid change of the vehicle speed occurs while the dynamic radar cruise control system is operating.

  • Vehicle speed sensors

  • Vehicle speed sensor signal circuit

  • Combination meter assembly

  • ECM

WIRING DIAGRAM

A01G735E19

INSPECTION PROCEDURE

This DTC may be set by the vehicle stability control system at the same time. In that case, perform troubleshooting for the vehicle stability control system first.

PROCEDURE


  1. CHECK FOR DTCs (ABS/VSC/TRAC)


    1. Connect the GTS to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Chassis / ABS/VSC/TRAC / Trouble Codes.

    5. Check for DTCs.

      Result
      Result Proceed to
      DTC is not output A
      DTC is output B

    6. Turn the engine switch off.


    B

    GO TO VEHICLE STABILITY CONTROL SYSTEM (DTC CHART) Click here

    A

  2. REPLACE COMBINATION METER ASSEMBLY

    Click here


    NEXT

  3. CHECK FOR DTCs


    1. Connect the GTS to the DLC3.

    2. Turn the engine switch on (IG).

    3. Clear the DTCs Click here.

    4. Perform the following to make sure that the DTC detection conditions are met.

      Tech Tips

      If the detection conditions are not met, the malfunction cannot be detected.


      1. Drive the vehicle at a speed for which cruise control operation is possible.

      2. Turn the dynamic radar cruise control system on using the cruise control switch (ON-OFF button).

      3. Push the cruise control switch to -SET to activate the dynamic radar cruise control system.

    5. Enter the following menus: Powertrain / Cruise Control / Trouble Codes.

    6. Check for DTCs Click here.

      Result
      Result Proceed to
      DTC is not output A
      DTC P0503 is output B

    7. Turn the engine switch off.


    B

    REPLACE ECM Click here

    A

    END