DYNAMIC RADAR CRUISE CONTROL SYSTEM Cruise SET Indicator Light Circuit

DESCRIPTION

• The ECM turns on the SET indicator light by sending indicator output demand signals to the combination meter assembly via CAN communication.

• The cruise control SET indicator light illuminates when the dynamic radar cruise control system is controlling vehicle speed.

• The cruise control SET indicator light circuit uses CAN communication. If the cruise control SET indicator light is not functioning correctly, check for CAN communication DTCs before troubleshooting this circuit.

WIRING DIAGRAM

Refer to Cruise Main Indicator Light Circuit Click here.

INSPECTION PROCEDURE

PROCEDURE

1. PERFORM ACTIVE TEST USING GTS (INDICAT. SET)

   
   

   1. Connect the GTS to the DLC3.

   2. Turn the engine switch on (IG).

   3. Turn the GTS on.

   4. Enter the following menus: Body Electrical / Combination Meter / Active Test.

   5. Check the cruise control SET indicator light by performing the Active Test.

      Combination Meter

      Tester Display	Test Part	Control Range	Diagnostic Note
      Indicat. SET	Cruise control SET indicator light	Cruise control SET indicator light ON / OFF	-

      OK
      The cruise control SET indicator light goes on or off.

   6. Turn the engine switch off.

   
   

   NG

   REPLACE COMBINATION METER ASSEMBLY Click here

   OK

   REPLACE PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here