STARTER INSTALLATION


  1. INSTALL STARTER ASSEMBLY


    1. Install the starter assembly with the 2 bolts.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

    2. Connect the connector.

    3. Connect the wire harness and install the nut, close the cap.

      Torque:
      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }

  2. INSTALL BATTERY


    1. Install the battery and battery tray.

    2. Install the battery clamp with the bolt and nut.

      Torque:
      Bolt
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }
      Nut
      3.5 N*m  { 36 kgf*cm, 31 in.*lbf }

    3. Connect the cable to the positive (+) battery terminal

      Torque:
      6.9 N*m  { 70 kgf*cm, 61 in.*lbf }

  3. INSTALL AIR CLEANER CASE SUB-ASSEMBLY


    1. A01G579E01
      Text in Illustration
      *a Hole
      *b Projection

      Insert the projection of the air cleaner case sub-assembly into the hole of the No. 2 air cleaner bracket as shown in the illustration.

    2. Install the 2 bolts.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

    3. Connect the wire harness clamp.

  4. INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

  5. INSTALL AIR CLEANER CAP SUB-ASSEMBLY


    1. A01G6AKE01
      Text in Illustration
      *a Hinge
      *b Clamp

      Connect the 2 hinges of the air cleaner cap sub-assembly.

    2. Install the air cleaner cap sub-assembly with the 2 clamps.

    3. Connect the air cleaner cap sub-assembly to the throttle with motor body assembly the hose clamp.

    4. Connect the ventilation hose to the cylinder head cover.

    5. Install the fuel vapor feed hose to the air cleaner hose.

    6. Connect the mass air flow meter connector and 2 wire harness clamps to the air cleaner cap sub-assembly.

    7. Connect the vacuum switching valve assembly to the air cleaner cap sub-assembly.

  6. INSTALL INLET AIR CLEANER ASSEMBLY


    1. Install the inlet air cleaner assembly with the 2 bolts.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

  7. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY


    1. Engage the 3 pins to install the No. 1 engine cover sub-assembly.

  8. INSTALL COOL AIR INTAKE DUCT SEAL


    1. Install the cool air intake duct seal with the 9 clips.

  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.