OIL LEVEL SENSOR INSTALLATION


  1. INSTALL ENGINE OIL LEVEL SENSOR


    1. Install a new gasket to the engine oil level sensor.

    2. Install the engine oil level sensor with the 4 bolts.

      Torque:
      8.2 N*m  { 84 kgf*cm, 73 in.*lbf }

    3. Connect the engine oil level sensor connector.

    4. Connect the engine oil pressure switch connector. (w/ Oil Cooler)

    5. Connect the wire harness protector. (w/ Oil Cooler)

  2. ADD ENGINE OIL


    1. A01G8XW

      Add clean engine oil and install the oil filler cap.

      Note

      Do not allow engine oil adhere to the moving parts of the belt tensioner, as this may cause malfunctions.

      If engine oil is on the location indicated by the arrow, replace the belt tensioner.

      Standard Oil Grade:
      Oil Grade Oil Viscosity (SAE)

      • API grade SL "Energy-Conserving", SM "Energy-Conserving", SN "Resource-Conserving" or ILSAC multigrade engine oil

      • 0W-20


      • 5W-20


      • 5W-30


      • 10W-30
      API grade SL, SM or SN multigrade engine oil

      • 15W-40


      • 20W-50
      Standard Capacity
      Item Standard Condition
      Drain and refill with oil filter change 6.1 liters (6.4 US qts, 5.4 Imp. qts)
      Drain and refill without oil filter change 5.7 liters (6.0 US qts, 5.0 Imp. qts)
      Dry fill 6.8 liters (7.2 US qts, 6.0 Imp. qts)

  3. INSPECT FOR ENGINE OIL LEAK

  4. INSPECT ENGINE OIL LEVEL


    1. Warm up the engine, stop it and wait 5 minutes. The engine oil level should be between the engine oil level dipstick low level mark and full level mark.

      If the engine oil level is low, check for leakage and add engine oil up to the full level mark.

      Note

      Do not add engine oil to above the full level mark.

  5. INSTALL FRONT FENDER APRON SEAL RH

  6. INSTALL ENGINE UNDER COVER RH

  7. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH

  8. INSTALL FRONT WHEEL RH

    Torque:
    103 N*m  { 1049 kgf*cm, 76 ft.*lbf }