OIL PRESSURE SWITCH INSTALLATION


  1. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY


    1. A01G4O4E15
      Text in Illustration
      *1 Adhesive

      Apply adhesive to 2 or 3 threads of the engine oil pressure switch assembly.

      Adhesive
      TOYOTA Genuine Adhesive 1344, Three Bond 1344 or equivalent.

      Note

      Do not let adhesive adhere to the oil hole.

    2. Using a 24 mm deep socket wrench, install the engine oil pressure switch assembly.

      Torque:
      15 N*m  { 153 kgf*cm, 11 ft.*lbf }

      Note

      Do not start the engine within 1 hour of installation.

    3. Connect the connector.

  2. INSPECT FOR OIL LEAK

  3. INSPECT ENGINE OIL LEVEL


    1. Warm up and stop the engine, and then wait 5 minutes.

    2. Check that the engine oil level is between the low level mark and full level mark on the engine oil level dipstick.

      If the level is low, check for leakage and add engine oil up to the full level mark.

      Note

      Do not fill the engine with oil to above the full level mark.