ROOM TEMPERATURE SENSOR INSTALLATION


  1. INSTALL COOLER (ROOM TEMP. SENSOR) THERMISTOR


    1. Connect the cooler thermistor hose and connector.

    2. Engage the 2 claws to install the cooler (room temp. sensor) thermistor.

  2. INSTALL SWITCH BASE


    1. for LHD:


      1. Connect the connector.

      2. Engage the 3 claws to install the switch base.

    2. for RHD:


      1. Connect the connector.

      2. Engage the 4 claws to install the switch base.

  3. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY


    1. Connect the connector.

    2. A01G4Z0

      Engage the 5 claws and 2 guides as shown in the illustration.

    3. Install the instrument cluster finish panel sub-assembly with the 2 screws <E>.

  4. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL


    1. for LHD:


      1. Connect each connector and engage each clamp.

      2. Engage the 12 claws, 2 clips and guide.

      3. Install the lower No. 1 instrument panel finish panel with the 2 bolts <B>.

    2. for RHD:


      1. Connect each connector and engage each clamp.

      2. Engage the 6 claws, 3 clips and guide.

      3. Install the lower No. 1 instrument panel finish panel with the 2 bolts <B>.

      4. A01G7GC

        Engage the 2 claws to close the cover as shown in the illustration.

  5. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    1. Engage the claw and 2 guides to connect the hood lock control lever sub-assembly.

  6. INSTALL INSTRUMENT SIDE PANEL


    1. A01G990

      Engage the 2 guides as shown in the illustration.

    2. A01G8LE

      Engage the 2 claws and 4 clips to install the instrument side panel LH as shown in the illustration.

  7. INSTALL FRONT DOOR OPENING TRIM COVER


    1. Engage the guide.

    2. Engage the 3 claws to install the front door opening trim cover LH.

  8. INSTALL COWL SIDE TRIM BOARD


    1. Engage the clip and claw.

    2. Install the cowl side trim board LH with the clip.

  9. INSTALL FRONT DOOR SCUFF PLATE


    1. Engage the 10 claws to install the front door scuff plate LH.

  10. INSTALL LOWER CENTER INSTRUMENT PANEL FINISH PANEL


    1. A01G96C

      Engage the 2 claws and 5 clips to install the lower center instrument panel finish panel as shown in the illustration.

  11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.