FRONT SEAT OUTER BELT ASSEMBLY INSPECTION


  1. INSPECT FRONT SEAT OUTER BELT ASSEMBLY (w/ Pre-crash System)


    1. A01G584E01
      Text in Illustration
      *1 Pretensioner Connector
      *2 Seat Belt Tension Reducer Connector
      *a

      Component without harness connected

      (Front Seat Outer Belt Assembly)

      Check seat belt tension reducer operation.

      Note

      Do not apply battery voltage to the pretensioner connector.


      1. Connect a positive (+) lead of the battery to terminal 1 of the seat belt tension reducer connector and a negative (-) lead to terminal 2.

      2. Check that an operating sound is heard when the magnetized solenoid is attracting the plunger.

      3. Pull out the seat belt and allow it to retract. Listen to the operating sound.

      4. Pull out the seat belt again, disconnect the negative (-) lead of the battery and allow the seat belt to retract. Listen to the operating sound again and check that the operating sound volume has increased.


        • If the result is not as specified, replace the front seat outer belt assembly.

    2. A01G7HLE01
      Text in Illustration
      *1 Pre-crash Seat Belt Connector
      *a

      Component without harness connected

      (Front Seat Outer Belt Assembly)

      Check the pre-crash seat belt.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        1 - 2 Always Below 1 MΩ

        • If the result is not as specified, replace the front seat outer belt assembly.

    3. A01G98PE09
      Text in Illustration
      *1 Retractor
      *a Unlocked
      *b Locked
      *c 45°

      Before installing the front seat outer belt assembly, check the ELR function.

      Note

      Do not disassemble the retractor.


      1. When the inclination of the retractor is 15° or less, check that the belt can be pulled from the retractor. When the inclination of the retractor is over 45°, check that the belt locks.

        If the result is not as specified, replace the outer belt assembly.

  2. INSPECT FRONT SEAT OUTER BELT ASSEMBLY (w/o Pre-crash System)


    1. A01G4T3E02
      Text in Illustration
      *1 Pretensioner Connector
      *2 Seat Belt Tension Reducer Connector
      *a

      Component without harness connected

      (Front Seat Outer Belt Assembly)

      Check seat belt tension reducer operation.

      Note

      Do not apply battery voltage to the pretensioner connector.


      1. Connect a positive (+) lead of the battery to terminal 1 of the seat belt tension reducer connector and a negative (-) lead to terminal 2.

      2. Check that an operating sound is heard when the magnetized solenoid is attracting the plunger.

      3. Pull out the seat belt and allow it to retract. Listen to the operating sound.

      4. Pull out the seat belt again, disconnect the negative (-) lead of the battery and allow the seat belt to retract. Listen to the operating sound again and check that the operating sound volume has increased.


        • If the result is not as specified, replace the front seat outer belt assembly.

    2. A01G98PE09
      Text in Illustration
      *1 Retractor
      *a Unlocked
      *b Locked
      *c 45°

      Before installing the front seat outer belt assembly, check the ELR function.

      Note

      Do not disassemble the retractor.


      1. When the inclination of the retractor is 15° or less, check that the belt can be pulled from the retractor. When the inclination of the retractor is over 45°, check that the belt locks.

        If the result is not as specified, replace the outer belt assembly.