FRONT SEAT OUTER BELT ASSEMBLY REMOVAL


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work Click here.

    Tech Tips


    • Use the same procedure for the RH side and LH side.

    • The following procedure is for the LH side.

  2. REMOVE SEAT BELT ANCHOR COVER CAP


    1. A01G85A

      Disengage the 6 guides and remove the seat belt anchor cover cap.

    2. Operate the power seat switch assembly and move the front seat assembly so that the nut for the anchor of the front seat outer belt assembly can be removed.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY


    1. A01G7IK

      Remove the nut and disconnect the anchor of the front seat outer belt assembly.

  5. REMOVE FRONT DOOR SCUFF PLATE


    1. A01G8TA

      Disengage the 10 claws and remove the front door scuff plate LH.

  6. REMOVE REAR DOOR SCUFF PLATE


    1. A01G5TH

      Disengage the 8 claws and remove the rear door scuff plate LH.

  7. REMOVE CENTER PILLAR LOWER GARNISH

    Tech Tips

    Use the same procedure as for the LH side.

  8. REMOVE CENTER PILLAR UPPER GARNISH


    1. A01G91V

      Remove the 2 screws.

    2. Disengage the clip.

    3. Pass the floor anchor of the front seat outer belt assembly LH through the center pillar upper garnish LH and remove the center pillar upper garnish LH.

  9. REMOVE FRONT SEAT OUTER BELT ASSEMBLY


    1. A01G8AT

      Remove the nut and disconnect the shoulder anchor of the front seat outer belt assembly.

    2. A01G92EE01
      Text in Illustration
      *1 Protective Tape
      *2 Pretensioner Connector
      *3 Pre-crash Safety Connector

      Using a screwdriver, pull out the locking button in the direction shown by the arrow in the illustration to release the lock, and disconnect the pretensioner connector as shown in the illustration.

      Tech Tips

      Tape the screwdriver tip before use.

    3. w/o Pre-crash Safety System:


      1. Disconnect the connector.

    4. w/ Pre-crash Safety System:


      1. Disconnect the 2 connectors.

    5. A01G4F0

      Remove the 2 bolts and front seat outer belt assembly.

  10. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY


    1. A01G6O8

      Remove the 2 bolts.

    2. Disengage the guide and remove the front shoulder belt anchor adjuster assembly.