FRONT SEAT ASSEMBLY INSTALLATION

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.


  1. INSTALL FRONT SEAT ASSEMBLY


    1. Place the front seat assembly in the cabin.

      Note

      Be careful not to damage the vehicle body.

    2. Connect each connector and engage each clamp under the seat.

    3. Connect the cable to the negative (-) battery terminal.

      Note

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

    4. Temporarily install the front seat assembly with the 4 bolts.

    5. Operate the slide and vertical power seat switch knob and move the seat to the rearmost position.

    6. A01G588E01

      Tighten the 2 bolts on the front side of the seat.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

      Note

      Tighten the bolts in the order indicated in the illustration.

    7. Operate the slide and vertical power seat switch knob and move the seat to the foremost position.

    8. A01G9SDE01

      Tighten the 2 bolts on the rear side of the seat.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

      Note

      Tighten the bolts in the order indicated in the illustration.

  2. INSTALL REAR INNER SEAT TRACK BRACKET COVER


    1. Engage the 2 claws to install the rear inner seat track bracket cover.

  3. INSTALL REAR OUTER SEAT TRACK BRACKET COVER


    1. Engage the 2 claws to install the rear outer seat track bracket cover.

  4. INSTALL FRONT INNER SEAT TRACK BRACKET COVER


    1. Operate the slide and vertical power seat switch knob and move the seat to the rearmost position.

    2. Engage the 2 claws to install the front inner seat track bracket cover.

  5. INSTALL FRONT OUTER SEAT TRACK BRACKET COVER


    1. Engage the 2 claws to install the front outer seat track bracket cover.

  6. CONNECT FRONT SEAT OUTER BELT ASSEMBLY


    1. Operate the power seat switch assembly and move the front seat assembly so that the nut for the anchor of the front seat outer belt assembly can be installed.

    2. A01G9AIE01
      Text in Illustration
      *1 Protruding Part

      Connect the anchor of the front seat outer belt assembly with the nut.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

      Note


      • Install the front seat outer belt assembly with the arrow on the anchor part facing the front of the vehicle.

      • Do not allow the anchor part of the front seat outer belt assembly to overlap the protruding parts of the front seat assembly.

  7. INSTALL SEAT BELT ANCHOR COVER CAP


    1. A01G8M7

      Engage the 6 guides and install the seat belt anchor cover cap.

  8. INSTALL FRONT SEAT HEADREST ASSEMBLY

  9. INSPECT FRONT SEAT ASSEMBLY


    1. Check power seat operation.

      w/o Memory: Click here

      w/ Memory: Click here

    2. w/ Seat Heater System:

      Check seat heater operation.


      1. Turn the engine switch on (IG).

      2. Turn the seat heater switch on.

      3. Wait 5 minutes or more and confirm that the seat surface becomes warm.

  10. INSPECT SRS WARNING LIGHT

    Click here