FUEL PUMP ECU REMOVAL


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE LUGGAGE COMPARTMENT FLOOR MAT


    1. Remove the luggage compartment floor mat.

  4. REMOVE SPARE WHEEL COVER PAD LH


    1. Remove the spare wheel cover pad LH.

  5. REMOVE SPARE WHEEL COVER PAD RH


    1. Remove the spare wheel cover pad RH.

  6. REMOVE LUGGAGE HOLD BELT STRIKER ASSEMBLY (for Rear Side)


    1. A01G6A7

      Remove the 2 bolts.

    2. Disengage the 2 guides and remove the 2 luggage hold belt striker assemblies.

  7. REMOVE REAR FLOOR FINISH PLATE


    1. A01G4NX

      Using a clip remover, remove the 3 clips.

    2. A01G8BW

      Disengage the 4 clips and remove the rear floor finish plate.

  8. REMOVE LUGGAGE HOLD BELT STRIKER ASSEMBLY (for LH Side)


    1. A01G8GX

      Remove the bolt.

    2. Disengage the guide and remove the luggage hold belt striker assembly.

  9. REMOVE ROPE HOOK (for LH Side)


    1. A01G9HY

      Disengage the 2 claws and remove the rope hook as shown in the illustration.

  10. REMOVE LUGGAGE COMPARTMENT INNER TRIM COVER LH


    1. A01G8WR

      Using a clip remover, remove the 3 clips.

    2. Disengage the 2 fasteners and remove the luggage compartment inner trim cover LH.

  11. REMOVE FUEL PUMP CONTROL ECU ASSEMBLY


    1. A01G57D

      Disconnect the connector and clamp from the fuel pump control ECU assembly.

    2. Remove the 2 nuts and fuel pump control ECU assembly.

      Note

      Do not reuse the fuel pump control ECU assembly if it has been dropped or subjected to a severe impact.

      Tech Tips

      If a malfunction such as pump lock occurs and the fuel pump is damaged, excessive current may be continuously applied to the fuel pump control ECU assembly, damaging its internal parts. Make sure to replace the fuel pump control ECU assembly at the same time when replacing the fuel pump with filter assembly.