FUEL PRESSURE PULSATION DAMPER INSTALLATION


  1. INSTALL FUEL PRESSURE PULSATION DAMPER ASSEMBLY


    1. A01G9RJE03
      Text in Illustration
      *1 O-ring

      Apply a light coat of gasoline or spindle oil to a new O-ring.

    2. Install the O-ring to the fuel pressure pulsation damper assembly.

    3. Install the fuel pressure pulsation damper assembly with the 2 bolts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note

      Make sure that the O-ring is not cracked or jammed when installing the damper.

  2. CONNECT FUEL TUBE SUB-ASSEMBLY

    A01G4Q6E02
    Text in Illustration
    *1 No. 2 Fuel Pipe Clamp
    *2 Fuel Hose Clamp

    1. Connect the fuel tube.

    2. Push the fuel tube connector until it makes a "click" sound.

    3. Install a new No. 2 fuel pipe clamp.

    4. Connect the fuel tube to the fuel hose clamp.

  3. INSTALL AIR CLEANER CAP SUB-ASSEMBLY


    1. A01G6AKE01
      Text in Illustration
      *a Hinge
      *b Clamp

      Connect the 2 hinges of the air cleaner cap sub-assembly.

    2. Install the air cleaner cap sub-assembly with the 2 clamps.

    3. Connect the air cleaner cap sub-assembly to the throttle with motor body assembly the hose clamp.

    4. Connect the ventilation hose to the cylinder head cover.

    5. Install the fuel vapor feed hose to the air cleaner hose.

    6. Connect the mass air flow meter connector and 2 wire harness clamps to the air cleaner cap sub-assembly.

    7. Connect the vacuum switching valve assembly to the air cleaner cap sub-assembly.

  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. INSPECT FOR FUEL LEAK


    1. Check fuel pump operation.


      1. Connect the GTS to the DLC3.

      2. Turn the engine switch on (IG) and turn the GTS on.

        Note

        Do not start the engine.

      3. Enter the following menus: Powertrain / Engine / Active Test / Control the Fuel Pump / Speed.

      4. Check for pressure in the fuel tube sub-assembly from the fuel pipe. Check that sounds of fuel flowing from the fuel tank can be heard. If no sounds can be heard, check the integration relay, fuel pump, ECM and wiring connectors.

    2. Inspect for fuel leaks.


      1. Check that there are no fuel leaks from the fuel system after doing any maintenance or repairs. If there is a fuel leak, repair or replace parts as necessary.

    3. Turn the engine switch off.

    4. Disconnect the GTS from the DLC3.

  6. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY


    1. Engage the 3 pins to install the No.1 engine cover sub-assembly.