AIR FUEL RATIO SENSOR REMOVAL


  1. REMOVE COOL AIR INTAKE DUCT SEAL


    1. A01G7XF

      Remove the 9 clips and cool air intake duct seal.

  2. REMOVE V-BANK COVER SUB-ASSEMBLY


    1. A01G4T2

      Hold the front of the V-bank cover sub-assembly and raise it to disengage the 2 retainers on the front of the V-bank cover sub-assembly. Continue to raise the V-bank cover sub-assembly to disengage the retainer on the rear of the V-bank cover sub-assembly and remove the V-bank cover sub-assembly.

      Note

      Attempting to disengage both front and rear retainers at the same time may cause the V-bank cover sub-assembly to break.

  3. REMOVE AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1)


    1. A01G8NN

      Disconnect the air fuel ratio sensor connector.

    2. A01G4FZ

      Remove the hose clamp.

    3. A01G8PTE01

      Using SST, remove the air fuel ratio sensor from the exhaust manifold LH.

      SST
      09224-00010

  4. REMOVE FRONT EXHAUST PIPE ASSEMBLY

    Click here.

  5. REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)


    1. A01G7B3

      Disconnect the air fuel ratio sensor connector.

    2. Disconnect the harness clamp.

    3. A01G9GTE01

      Using SST, remove the air fuel ratio sensor from the exhaust manifold RH.

      SST
      09224-00010