DRIVE BELT INSTALLATION


  1. INSTALL V-RIBBED BELT


    1. A01G9CSE02
      Text in Illustration
      *1 Crankshaft Pulley
      *2 V-ribbed belt Tensioner Assembly
      *3 Generator Assembly
      *4 Engine Water Pump Assembly
      *5 Cooler Compressor

      Set the V-ribbed belt onto each part as shown in the illustration except the engine water pump pulley.

    2. Loosen the V-ribbed belt by turning the belt tensioner clockwise.

    3. Set the V-ribbed belt onto the water pump pulley.

      Note

      Make sure that the V-ribbed belt is attached to each pulley. In particular, make sure that the V-ribbed belt is securely fitted into the grooves of each pulley.

  2. INSTALL FRONT FENDER APRON SEAL RH

  3. INSTALL ENGINE UNDER COVER RH

  4. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH

  5. INSTALL FRONT WHEEL RH

    Torque:
    103 N*m  { 1049 kgf*cm, 76 ft.*lbf }