ENGINE COOLANT TEMPERATURE SENSOR REMOVAL


  1. DRAIN ENGINE COOLANT

    Note

    Do not remove the radiator cap sub-assembly or radiator drain cock plug while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.


    1. Loosen the radiator drain cock plug.

    2. Remove the radiator cap sub-assembly.

      A01G5I0E01
      Text in Illustration
      *1 Radiator Cap Sub-assembly *2 Radiator Drain Cock Plug

      Tech Tips

      Collect the engine coolant in a container and dispose of it according to the regulations in your area.

  2. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    1. A01G6L6

      Lift the rear of the No. 1 engine cover sub-assembly to detach it from the 2 pins.

    2. Lift the front of the No. 1 engine cover sub-assembly to detach the it from the pin and remove it.

      Note

      Attempting to disengage both front and rear pins at the same time may cause the No. 1 engine cover sub-assembly to break.

  3. REMOVE COOL AIR INTAKE DUCT SEAL


    1. A01G7XF

      Remove the 9 clips and cool air intake duct seal.

  4. REMOVE INLET AIR CLEANER ASSEMBLY


    1. A01G7TY

      Remove the 2 bolts and inlet air cleaner assembly.

  5. REMOVE ENGINE COOLANT TEMPERATURE SENSOR


    1. A01G59K

      Disconnect the engine coolant temperature sensor connector.

    2. A01G88C

      Remove the 2 bolts and disconnect the wire harness.

    3. A01G7ITE01
      Text in Illustration
      *1 Ball Joint Lock Nut Wrench
      *2 Gasket

      Using a 19 mm ball joint lock nut wrench, remove the engine coolant temperature sensor.

    4. Remove the gasket from the engine coolant temperature sensor.