BLACK OUT TAPE(for Rear Door) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the LH side and RH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notices before proceeding with work Click here.

  2. REPAIR INSTRUCTION

    Click here

  3. INSTALL FRONT INNER BLACK OUT TAPE


    1. Refer to the illustration to position a new front inner black out tape.

      A0009DTE01
      Text in Illustration
      *A LH Side *B RH Side
      *a Edge of Curved Surface *b Straight
      *c Triangle - -
      Standard Measurement
      Dimension Measurement
      A 1.5 mm (0.0591 in.)
      B 1.0 mm (0.0394 in.)

    2. Remove the release paper and apply the front inner black out tape.

  4. INSTALL REAR INNER BLACK OUT TAPE


    1. Refer to the illustration to position a new rear inner black out tape.

      A00089EE04
      Text in Illustration
      *A LH Side *B RH Side
      *a Edge of Curved Surface *b Straight
      *c Triangle - -
      Standard Measurement
      Dimension Measurement
      A 1.5 mm (0.0591 in.)
      B 1.0 mm (0.0394 in.)

    2. Remove the release paper and apply the rear inner black out tape.

  5. INSTALL CURTAIN HOOK (w/ Rear Door Sunshade)

    Click here

  6. INSTALL REAR DOOR FRAME GARNISH

    Click here

  7. INSTALL REAR DOOR GLASS ASSEMBLY

    Click here

  8. INSTALL REAR DOOR QUARTER WINDOW GLASS

    Click here

  9. INSTALL REAR DOOR LOWER WINDOW FRAME SUB-ASSEMBLY

    Click here

  10. INSTALL REAR DOOR NO. 1 VENT SEAL

    Click here

  11. INSTALL REAR DOOR GLASS RUN

    Click here

  12. CONNECT REAR DOOR WEATHERSTRIP

    Click here

  13. INSTALL REAR DOOR SERVICE HOLE COVER

    Click here

  14. INSTALL REAR DOOR ARMREST SET BRACKET

    Click here

  15. INSTALL REAR DOOR INNER GLASS WEATHERSTRIP

    Click here

  16. INSTALL REAR SIDE CURTAIN ASSEMBLY (w/ Rear Door Sunshade)

    Click here

  17. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  18. INSTALL COURTESY LIGHT ASSEMBLY

    Click here

  19. INSTALL REAR DOOR NO. 1 STIFFENER CUSHION

    Click here

  20. INSTALL DOOR PULL HANDLE COVER

    Click here

  21. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

    Click here

  22. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG

    Click here

  23. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  24. INSTALL LUGGAGE TRIM SERVICE HOLE COVER

    Click here

  25. INITIALIZE POWER WINDOW CONTROL SYSTEM

    Click here

  26. INSPECT POWER WINDOW OPERATION

    Click here