BLACK OUT TAPE(for Rear Door) REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE

1. Click here

   PRECAUTION

   Note:

   After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notices before proceeding with work (Click here).

2. Click here

   REMOVE LUGGAGE TRIM SERVICE HOLE COVER

   Click here

3. Click here

   DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

   Note:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

4. Click here

   REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG

   Click here

5. Click here

   REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

   Click here

6. Click here

   REMOVE DOOR PULL HANDLE COVER

   Click here

7. Click here

   REMOVE REAR DOOR NO. 1 STIFFENER CUSHION

   Click here

8. Click here

   REMOVE COURTESY LIGHT ASSEMBLY

   Click here

9. Click here

   REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

   Click here

10. Click here

    REMOVE REAR DOOR INNER GLASS WEATHERSTRIP

    Click here

11. Click here

    REMOVE REAR SIDE CURTAIN ASSEMBLY (w/ Rear Door Sunshade)

    Click here

12. Click here

    REMOVE REAR DOOR ARMREST SET BRACKET

    Click here

13. Click here

    REMOVE REAR DOOR SERVICE HOLE COVER

    Click here

14. Click here

    DISCONNECT REAR DOOR WEATHERSTRIP

    Click here

15. Click here

    REMOVE REAR DOOR GLASS RUN

    Click here

16. Click here

    REMOVE REAR DOOR NO. 1 VENT SEAL

    Click here

17. Click here

    REMOVE REAR DOOR LOWER WINDOW FRAME SUB-ASSEMBLY

    Click here

18. Click here

    REMOVE REAR DOOR QUARTER WINDOW GLASS

    Click here

19. Click here

    REMOVE REAR DOOR GLASS ASSEMBLY

    Click here

20. Click here

    REMOVE REAR DOOR FRAME GARNISH

    Click here

21. Click here

    REMOVE CURTAIN HOOK (w/ Rear Door Sunshade)

    Click here

22. Click here

    REMOVE REAR INNER BLACK OUT TAPE

    
    

    1. Using a heat light, heat the rear inner black out tape and vehicle body.

       Table 1. Heating Temperature

       Item	Temperature
       Vehicle Body and Rear Inner Black Out Tape	40 to 60°C (104 to 140°F)

       Note:

       Do not heat the vehicle body excessively.

    2. 

       Pull back on one of the ends of the rear inner black out tape to remove it.

       Tip:

       When pulling on the black out tape, pull it parallel to the body.

23. Click here

    REMOVE FRONT INNER BLACK OUT TAPE

    
    

    1. Using a heat light, heat the front inner black out tape and vehicle body.

       Table 2. Heating Temperature

       Item	Temperature
       Vehicle Body and Front Inner Black Out Tape	40 to 60°C (104 to 140°F)

       Note:

       Do not heat the vehicle body excessively.

    2. 

       Pull back on one of the ends of the front inner black out tape to remove it.

       Tip:

       When pulling on the black out tape, pull it parallel to the body.