BLACK OUT TAPE(for Rear Door) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the LH side and RH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notices before proceeding with work Click here.

  2. REMOVE LUGGAGE TRIM SERVICE HOLE COVER

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG

    Click here

  5. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

    Click here

  6. REMOVE DOOR PULL HANDLE COVER

    Click here

  7. REMOVE REAR DOOR NO. 1 STIFFENER CUSHION

    Click here

  8. REMOVE COURTESY LIGHT ASSEMBLY

    Click here

  9. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  10. REMOVE REAR DOOR INNER GLASS WEATHERSTRIP

    Click here

  11. REMOVE REAR SIDE CURTAIN ASSEMBLY (w/ Rear Door Sunshade)

    Click here

  12. REMOVE REAR DOOR ARMREST SET BRACKET

    Click here

  13. REMOVE REAR DOOR SERVICE HOLE COVER

    Click here

  14. DISCONNECT REAR DOOR WEATHERSTRIP

    Click here

  15. REMOVE REAR DOOR GLASS RUN

    Click here

  16. REMOVE REAR DOOR NO. 1 VENT SEAL

    Click here

  17. REMOVE REAR DOOR LOWER WINDOW FRAME SUB-ASSEMBLY

    Click here

  18. REMOVE REAR DOOR QUARTER WINDOW GLASS

    Click here

  19. REMOVE REAR DOOR GLASS ASSEMBLY

    Click here

  20. REMOVE REAR DOOR FRAME GARNISH

    Click here

  21. REMOVE CURTAIN HOOK (w/ Rear Door Sunshade)

    Click here

  22. REMOVE REAR INNER BLACK OUT TAPE


    1. Using a heat light, heat the rear inner black out tape and vehicle body.

      Heating Temperature
      Item Temperature
      Vehicle Body and Rear Inner Black Out Tape 40 to 60°C (104 to 140°F)

      Note

      Do not heat the vehicle body excessively.

    2. A00041Q

      Pull back on one of the ends of the rear inner black out tape to remove it.

      Tech Tips

      When pulling on the black out tape, pull it parallel to the body.

  23. REMOVE FRONT INNER BLACK OUT TAPE


    1. Using a heat light, heat the front inner black out tape and vehicle body.

      Heating Temperature
      Item Temperature
      Vehicle Body and Front Inner Black Out Tape 40 to 60°C (104 to 140°F)

      Note

      Do not heat the vehicle body excessively.

    2. A00076N

      Pull back on one of the ends of the front inner black out tape to remove it.

      Tech Tips

      When pulling on the black out tape, pull it parallel to the body.