ROOF DRIP SIDE FINISH MOULDING INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. Click here

   INSTALL NO. 1 ROOF DRIP SIDE FINISH MOULDING CLIP

   Note:

   When installing new clips, remove the double-sided tape remaining where the clips will be installed on the body and clean the body with a non-residue solvent.

   
   
   1. 

      Apply a 2 to 3 mm (0.0787 to 0.118 in.) bead of adhesive (3M DP-105 or equivalent) to 2 new No. 1 roof drip side finish moulding clips.

      Table 1. Text in Illustration

      *1	Adhesive
      *a	2 to 3 mm Bead of Adhesive

      Tip:

      Adhesive strength (tensile strength): 13.7 MPa (140.0 kgf/cm², 1987 psi) or more (when the temperature is 23°C (73°F))

   2. 

      Install the 2 new No. 1 roof drip side finish moulding clips to the positions on the roof panel shown in the illustration. Determine the locations and firmly press and install the 2 No. 1 roof drip side finish moulding clips after lightly applying adhesive (3M DP-105 or equivalent).

      Table 2. Text in Illustration

      *a	Protruding Part

      Table 3. Standard Dimension

      Installation Area	Dimension	Measurement
      for Front Side	A	3.0 mm (0.118 in.)
      	B	3.4 mm (0.134 in.)
      	C	3.0 mm (0.118 in.)
      	D	3.0 mm (0.118 in.)
      for Rear Side	E	2.9 mm (0.114 in.)
      	F	3.9 mm (0.154 in.)
      	G	3.5 mm (0.138 in.)
      	H	3.5 mm (0.138 in.)

   3. Install the center roof drip side finish moulding when 20 minutes or more have elapsed after pressing and installing the No. 1 roof drip side finish moulding clips.

      Tip:
      

      • Initial hardening time: 20 minutes

      • Complete hardening time: 48 hours

2. Click here

   INSTALL CENTER ROOF DRIP SIDE FINISH MOULDING

   
   
   1. 

      Engage the 2 clips and install the center roof drip side finish moulding.